Series 2600B System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2600BS-901-01 Rev. B / May 2013
7-77
Also see
display.clear()
(on page 7-60)
display.getcursor()
(on page 7-62)
display.gettext()
(on page 7-64)
display.screen
(on page 7-73)
display.setcursor()
(on page 7-75)
display.smuX.digits
This attribute sets the display resolution of the selected measurement.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
Instrument reset
Recall setup
Saved setup
5 (display.DIGITS_5_5)
Usage
digits
= display.smu
X
.digits
display.smu
X
.digits =
digit
s
digits
Set digits to one of the following values:
•
Select 4-1/2 digit resolution (
4
or
display.DIGITS_4_5)
•
Select 5-1/2 digit resolution (
5
or
display.DIGITS_5_5)
•
Select 6-1/2 digit resolution (
6
or
display.DIGITS_6_5)
X
Source-measure unit (SMU) channel (for example,
display.smua.digits
applies to SMU channel A)
Details
SMU A and SMU B can be set for different measurement display resolutions.
Example
display.smua.digits = display.DIGITS_5_5
Select 5-1/2 digit resolution for SMU A.
Also see
Display resolution
(on page 3-72)
display.smuX.limit.func
On single SMU display screens, this attribute specifies the type of limit value setting displayed.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
Instrument reset
Recall setup
Saved setup
0 (display.LIMIT_IV)
Summary of Contents for System SourceMeter 2601B
Page 841: ......