![background image](http://html2.mh-extra.com/html/keithley/system-sourcemeter-2601b/system-sourcemeter-2601b_reference-manual_4009934375.webp)
Series 2600B System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2600BS-901-01 Rev. B / May 2013
7-35
ConfigPulseIMeasureVSweepLin()
This KIPulse factory script function configures a linear pulsed current sweep with a voltage measurement at each
point.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
No
Usage
f
,
msg
= ConfigPulseIMeasureVSweepLin(
smu, bias, start, stop, limit, ton, toff,
points, buffer, tag, sync_in, sync_out, sync_in_timeout, sync_in_abort
)
f
,
msg
= ConfigPulseIMeasureVSweepLin(
smu, bias, start, stop, limit, ton, toff,
points, buffer, tag, sync_in, sync_out, sync_in_timeout
)
f
,
msg
= ConfigPulseIMeasureVSweepLin(
smu, bias, start, stop, limit, ton, toff,
points, buffer, tag, sync_in, sync_out
)
f
,
msg
= ConfigPulseIMeasureVSweepLin(
smu, bias, start, stop, limit, ton, toff,
points, buffer, tag, sync_in
)
f
,
msg
= ConfigPulseIMeasureVSweepLin(
smu, bias, start, stop, limit, ton, toff,
points, buffer, tag
)
f
A Boolean flag; this flag is
true
if the pulse was successfully configured,
false
when errors
were encountered
msg
A string message; if the
f
flag is
false
,
msg
contains an error message; if it is
true
,
msg
contains a string indicating successful configuration
smu
System SourceMeter
®
instrument channel (for example,
smua
refers to SMU channel A)
bias
Bias level in amperes
start
Pulse sweep start level in amperes
stop
Pulse sweep stop level in amperes
limit
Voltage limit (for example, compliance) in volts
ton
Pulse on time in seconds
toff
Pulse off time in seconds
points
Number of pulse-measure cycles
buffer
Reading buffer where pulsed measurements will be stored; if this is
nil
when the function is
called, no measurements will be made when the pulse train is initiated
tag
Numeric identifier to be assigned to the defined pulse train
sync_in
Defines a digital I/O trigger input line; if programmed, the pulse train will wait for a trigger input
before executing each pulse
sync_out
Defines a digital I/O trigger output line; if programmed, the pulse train will generate a trigger
output immediately before the start of
ton
sync_in_timeout
Specifies the length of time (in seconds) to wait for input trigger; default value is 10 s
sync_in_abort
Specifies whether or not to abort pulse if input trigger is not received; if pulse aborts because of
a missed trigger, a timer timeout message is returned;
true
or
false
Summary of Contents for System SourceMeter 2601B
Page 841: ......