Series 2200 power Supplies Quick Start Guide
Front Panel Operation
STEP 1 Setting the Output Voltage
1.
Press V-Set.
2.
Use the arrow keys, numeric keypad, or the navigation wheel to enter the desired voltage
output value.
3.
Press Enter to set the voltage.
STEP 2 Setting the Current Limit
1.
Press I-Set.
2.
Use the arrow keys, numeric keypad, or the navigation wheel to enter the current limit.
3.
Press Enter to set the current.
STEP 3 Turning on the Output
1.
Press Output ON/OFF
Remote Operation
The following SCPI command example resets the power supply, sets the voltage output to 3.33V, the
current limit to 1.6A and turns the output on.
*RST
SOURCE:FUNC:MODE FIX
SOURCE:VOLT 3.33V
SOURCE:CURR 1.6A
SOURCE:OUTP:ON
Connecting a Device
OPTION 1
Using Local Sense (Lead Wire Resistance not Compensated)
1.
Install the shorting clip (included in accessories) on the rear panel terminal strip as shown in
Figure 1 below. You may also use jumpers between DRIVE+ and SENSE+, and between DRIVE-
and SENSE-.
Figure 1 Rear Panel Shorting Clips
