Keithley KPCI-3101 Series, User Manual

Page: 59 / 146

KPCI-3101 — KPCI-3104 Series User’s Manual Installation and Configuration 3-7
Configuring the board to work with DriverLINX
After physically installing the board, turn on and reboot the computer. The DriverLINX Plug
and Play Wizard screen appears. Run the Wizard immediately by following the progressive
instructions on the screen.
If you do not run the Wizard immediately, it will not appear the next time you reboot. You must
then restart the Wizard from a batch file, as follows:
1. Open the Windows Explorer.
2. Double click on X:\DrvLINX4\Help\kcpi3100.bat, where X = the letter of the drive on
which you installed DriverLINX.
3. The Wizard appears.
NOTE
You can also start this batch file directly from the CD-ROM by double
clicking on Y:\DrvLINX4\Help\kpci3100.bat, where Y = the drive letter
of your CD-ROM drive.
Checking the combined board and DriverLINX installations
Before making any connections to the board, check whether DriverLINX and your board are
installed correctly and working together properly. Refer to
Section 4 , “Testing the Board” and
the DriverLINX manuals.
Try starting the DriverLINX Analog I/O Panel. Proceed as follows:
1. In the Start menu, click Programs.
2. Find the DriverLINX
→
Test Panels folder, under which you should find the AIO Panel
entry.
3. Click on the AIO Panel entry.
4. If a KPCI-3101–4 Series board is the only board in your computer installed under Driver-
LINX or if the DriverLINX Analog I/O Panel lists the KPCI3101–4 board under Driver
Selection, then DriverLINX and your board are installed properly and are working together.
5. If you cannot initially run the Analog I/O Panel, refer to Section 6 , “Troubleshooting” .
After DriverLINX and your board are installed properly and working together, continue with
installation and wiring.