Section 8: TSP command reference
Model 2450 Interactive SourceMeter® Instrument Reference Manual
8-226
2450-901-01 Rev. B/September 2013
trigger.tsplinkin[N].overrun
This attribute indicates if the event detector ignored an event while in the detected state.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Instrument reset
Recall setup
TSP-Link line
N
clear
TSP-Link line
N
reset
Not applicable
Not applicable
Usage
overrun
= trigger.tsplinkin[
N
].overrun
overrun
Trigger overrun state
N
The trigger line (1 to 3)
Details
Indicates that an event was ignored because the event detector had already detected an event when another
event was detected.
Indicates the overrun state of the event detector built into the line.
It does not indicate whether an overrun occurred in any other part of the trigger model or in any other detector
that is monitoring the event.
It does not indicate output trigger overrun.
Example
print(trigger.tsplinkin[1].overrun)
If an event on line 1 was ignored,
displays
true
; if no additional event
occurred, displays
false
.
Also see
None
trigger.tsplinkin[N].wait()
This function waits for a trigger.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
triggered
= trigger.tsplinkin[
N
].wait(
timeout
)
triggered
Trigger detection indication; set to one of the following values:
true
: A trigger is detected during the timeout period
false
: A trigger is not detected during the timeout period
N
The trigger line (1 to 3)
timeout
The timeout value in seconds
