In this section:
Instrument power ..................................................................... 2-1
Front-panel overview ................................................................ 2-3
Rear panel overview ................................................................ 2-6
Touchscreen display ................................................................ 2-8
Screen descriptions ................................................................ 2-12
Examples in this manual ........................................................ 2-55
Display features ..................................................................... 2-55
Dimensions ............................................................................ 2-60
Handle and bumpers .............................................................. 2-62
Remote communications interfaces ....................................... 2-64
Determining the command set you will use ............................ 2-89
System information ................................................................ 2-90
Instrument sounds .................................................................. 2-91
Test connections .................................................................... 2-92
DMM measurement overview ................................................. 2-94
Auto Delay............................................................................ 2-137
Detector bandwidth .............................................................. 2-140
Graphing .............................................................................. 2-141
Binning data with the Histogram ........................................... 2-148
Automatic reference measurements .................................... 2-149
Saving setups ....................................................................... 2-150
Using the event log .............................................................. 2-154
Resets .................................................................................. 2-155
Instrument power
Follow the steps below to connect the Model DMM7510 to line power and turn on the instrument. The
Model DMM7510 operates from a line voltage of 100 V to 240 V at a frequency of 50 Hz or 60 Hz. It
automatically senses line voltage and frequency. Make sure the operating voltage in your area is
compatible.
You must turn on the Model DMM7510 and allow it to warm up for at least 90 minutes to achieve
rated accuracies.
Operating the instrument on an incorrect line voltage may cause damage to the instrument, possibly
voiding the warranty.
Section 2
General operation