Section 6: Clarius
Model 4200A-SCS Parameter Analyzer Reference Manual
6-162
4200A-901-01 Rev. C / February 2017
Set up List Stress/Measure
Information that is entered when Linear or Log is selected is shown when List is selected. You can
use those settings as a starting point when you set up your list.
To set timing for list mode:
1. Select
List
.
2. If needed, enter the
Stress/Measure Delay
in seconds. This is the delay after each stress cycle.
It allows the device to reach equilibrium before the next measurement.
3. Enter a
Stress Time
in seconds.
4. Select
Add
to add the time to the Stress Times list.
5. Continue adding stress times as needed.
6. To remove a stress time, select the time in the list and select
Remove
.
Figure 325: Set timing for stress/measure List mode
