Keithley 4200-SCS, User Manual

Page: 308 / 335

4-42 Return to Section Topics 4200-900-01 Rev. K / February 2017
Section 4: How to Control Other Instruments with the Model 4200-SCS Model 4200-SCS User Manual
Add a UTM
To add the cvsweep UTM to the new project by copying it from the default test library
(
C:\S4200\kiuser\tests
):
1. In the project navigator, double-click the Capacitor device to open the device plan window.
2. On the sequence tab of the device plan window, use the Test Library pull-down menu to
select the default test library as shown in Figure 4-68 .
3. Double-click the Capacitor folder to open it and display the available tests for that device.
Figure 4-69 A shows the Capacitor folder opened.
4. For the Capacitor folder, click cvsweep to select it. Figure 4-69 shows cvsweep selected.
5. Click Copy to place the test in the test sequence table. Figure 4-69 shows cvsweep copied
into the test sequence table.
6. At the bottom of the device plan window, click Apply to copy the test into the project
navigator. Figure 4-69 B shows the cvsweep UTM added to the project.
7. If desired, the device plan window may be closed by pressing the close (X) button. The
close ( X ) button is located on the right, above the device plan window.
Figure 4-68
Default test library folders
Figure 4-69
Add the cvsweep UTM
A. Window to specify the test module name B. Project navigator