Section 11: TSP command reference
Series 3700A System Switch/Multimeter Reference Manual
11-440
3700AS-901-01 Rev. D/June 2018
tspnet.reset()
This function disconnects all TSP-Net sessions.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
No
Usage
tspnet.reset()
Details
This command disconnects all remote instruments connected through TSP-Net. For TSP-enabled
devices, this causes any commands or scripts running remotely to be terminated.
Also see
None
tspnet.termination()
This function sets the device line termination sequence.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
No
Usage
type
= tspnet.termination(
connectionID
)
type
= tspnet.termination(
connectionID
,
termSequence
)
type
An enumerated value indicating the termination type:
▪
1
or
tspnet.TERM_LF
▪
4
or
tspnet.TERM_CR
▪
2
or
tspnet.TERM_CRLF
▪
3
or
tspnet.TERM_LFCR
connectionID
The connection ID returned from
tspnet.connect()
termSequence
The termination sequence
Details
This function sets and gets the termination character sequence that is used to indicate the end of a
line for a TSP-Net connection.
Using the
termSequence
parameter sets the termination sequence. The present termination
sequence is always returned.
For the
termSequence
parameter, use the same values listed in the table above for type. There are
four possible combinations, all of which are made up of line feeds (LF or 0x10) and carriage returns
(CR or 0x13). For TSP-enabled devices, the default is
tspnet.TERM_LF
. For devices that are not
TSP-enabled, the default is
tspnet.TERM_CRLF
.
