Keithley 2700, User Manual, Page: 384 / 500

Model 2700 Multimeter/Switch System User’s Manual SCPI Reference Tables 15-21
Table 15-7
SYSTem command summary
Command Description
Default
parameter Ref SCPI
SYSTem
:PRESet Return to :SYST:PRES defaults. Sec 14
✓
:POSetup <name> Select power-on setup: (RST, PRESet, SAV0,
SAV1, SAV2, or SAV3).
Sec 1
:POSetup? Query power-on setup.
:FRSWitch? Query INPUTS switch (0=rear, 1=front). Sec 1
:BEEPer Path to control beeper. Sec 14
[:STATe] <b> Enable or disable beeper. ON
✓
[:STATe]? Query state of beeper.
✓
:KCLick <b> Turn the keyclick on/off. ON Sec 1
:KCLick? Query the keyclick status.
:KEY <NRf> Simulate key-press (1 to 31; see Figure 14-3). Sec 14
✓
:KEY? Query the last “pressed” key.
✓
:AZERo Path to set up autozero. Sec 3
[:STATe] <b> Enable or disable autozero. ON
[:STATe]? Query autozero.
:LSYNc Path to control line synchronization: Sec 3
[:STATe] <b> Enable or disable line-sync. OFF
[:STATe]? Query state of line-sync.
:LFRequency? Query power line frequency. Sec 1
:FRESistance Path to select 4-wire ohms mode: Sec 3
:TYPEx <name> Select 4-wire ohms mode (NORMal or CSIDe)
for 7701 installed in slot x (x = 1 or 2).
:TYPEx? Query selected 4-wire ohms mode.
:PCARdX <name> Set up an empty slot (X = 1 or 2) as a pseudocard
(C7700, C7701, C7702, C7703, C7705, C7706,
C7707, 7708, C7709, C7710, C7711, C7712).
Sec 2
:CARDX Path to query switching module in specified slot
1
(X = slot number for module).
:SNUMber? Request serial number
2
.
:SWRevision? Request firmware revision
2
.
:VMAX? Request maximum allowable voltage.
:MUX? Support multiplexer channels?; 1 = yes, 0 = no.
:ISOLated? Support isolated channels?; 1 = yes, 0 = no.
:TCOMpensated? Built-in temperature sensors for T/C cold
junction?; 1 = yes, 0 = no.
:VCHannel Path to query volts/2-wire channels: