Keithley 2700, User Manual, Page: 35 / 500

1-18 Getting Started Model 2700 Multimeter/Switch System User’s Manual
Keyclick
With keyclick enabled, an audible click will sound when a front panel key is pressed.
Perform the following steps to disable or enable keyclick:
1. Press SHIFT and then LOCAL to display the present state of KEYCLICK (ON or
OFF).
2. Press
Δ
or
∇
to display the desired keyclick state and press ENTER.
Remote programming
The following command controls keyclick:
SYSTem:KCLick <b> ' Enable or disable keyclick.
where: <b> = ON or OFF
NOTE
Keyclick ON is the FACTORY, *RST, and SYSTem:PRESet default.
Display
Readings are displayed in engineering units (i.e., 100.23mV), while annunciators indicate
various states of operation. See
“Front panel summary,” page 1-10 , for a complete listing
of display annunciators.
NOTE
The display test allows you to test display digit segments and annunciators. The
key test checks the functionality of front panel keys. These tests are accessed by
pressing SHIFT and then TEST. Refer to the Model 2700 Service Manual for
details.
Status and error messages
Status and error messages are displayed momentarily. During operation and programming,
you will encounter a number of front panel messages. Typical messages are either of status
or error variety, as listed in
Appendix C .
Remote programming — display
Using remote programming, the Model 2700 can display a custom ASCII message (up to
12 characters). Also, the front panel display and controls can be disabled.
Display commands
The commands are listed in Table 1-3 . Details on these commands follow the table.