Keithley 2606B System SourceMeter, Reference Manual

Page: 634 / 756

Section 7: TSP command reference 2606B System SourceMeter® Instrument Reference Manual
7-350 2606B-901-01 Rev. B / May 2018
Also see
trigger.timer[N].reset() (on page 7-352)
trigger.timer[N].EVENT_ID
This constant specifies the trigger timer event number.
Type TSP-Link accessible Affected by Where saved Default value
Constant Yes
Usage
eventID = trigger.timer[ N ].EVENT_ID
eventID
The trigger event number
N Trigger timer number (1 to 8)
Details
This constant is an identification number that identifies events generated by this timer.
Set the stimulus of any trigger object to the value of this constant to have the trigger object respond to
events from this timer.
Example
trigger.timer[1].stimulus = tsplink.trigger[2].EVENT_ID Sets the trigger stimulus of
trigger timer 1 to the TSP-
Link trigger 2 event.
Also see
None
trigger.timer[N].overrun
This attribute indicates if an event was ignored because of the event detector state.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R) Yes Instrument reset
Recall setup
Trigger timer N clear
Trigger timer N reset Not applicable false
Usage
overrun = trigger.timer[ N ].overrun
overrun Trigger overrun state (
true
or
false
)
N Trigger timer number (1 to 8)
Details
This command indicates if an event was ignored because the event detector was already in the
detected state when the event occurred.