Section 8: TSP command reference
Model 2461 Interactive SourceMeter® Instrument Reference Manual
8-298
2461-901-01 A/November 2015
Example 2
print(trigger.model.getblocklist())
Query the configuration of the blocks in the trigger model.
Output:
4) SOURCE_OUTPUT OUTPUT: ON
5) SOURCE_PULSE_OUTPUT PULSE OUTPUT: ON
Also see
trigger.model.setblock() — trigger.BLOCK_SOURCE_OUTPUT
(on page 8-296)
trigger.model.setblock() — trigger.BLOCK_WAIT
This function defines a trigger model block that waits for an event before allowing the trigger model to continue.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Restore configuration
Instrument reset
Power cycle
Configuration script
Not applicable
Usage
trigger.model.setblock(
blockNumber
, trigger.BLOCK_WAIT,
event
)
trigger.model.setblock(
blockNumber
, trigger.BLOCK_WAIT,
event, clear
)
trigger.model.setblock(
blockNumber
, trigger.BLOCK_WAIT,
event
,
clear
,
logic, event
)
trigger.model.setblock(
blockNumber
, trigger.BLOCK_WAIT,
event
,
clear
,
logic, event,
event
)
blockNumber
The sequence of the block in the trigger model
event
The event that must occur before the trigger block allows trigger execution
to continue (see
Details
)
clear
To clear previously detected trigger events when entering the wait block:
trigger.CLEAR_ENTER
To immediately act on any previously detected triggers and not clear them
(default):
trigger.CLEAR_NEVER
logic
If each event must occur before the trigger model continues:
trigger.WAIT_AND
If at least one of the events must occur before the trigger model continues:
trigger.WAIT_OR
Details
You can use the wait block to synchronize measurements with other instruments and devices.
You can set the instrument to wait for the following events:
•
Front-panel TRIGGER key press
•
Notify (only available when using remote commands)
•
Command interface trigger
•
Digital input/output signals, such as DIGIO and TSP-Link
•
LAN
•
Blender
•
Timer
•
Source limit condition