Model 2461 Interactive SourceMeter® Instrument Reference Manual
Section 8: TSP command reference
2461-901-01 A/November 2015
8-273
limit4Pattern
The bit pattern that is sent when the measurement passes limit 4; range 1
to 15; default is 8
allPattern
The bit pattern that is sent when all limits have failed; 1 to 15; default is 15
startInLine
The input line that starts the test;
5
for digital line 5,
6
for digital line 6;
default is 5
startDelay
The delay time before each measurement (167 ns to 10 ks); default is 0 for
no delay
endDelay
The delay time after the measurement (167 ns to 10 ks); default is 0 for no
delay
bufferName
The name of the reading buffer, which may be a default buffer
(
defbuffer1
or
defbuffer2
) or a user-defined buffer; defaults to
defbuffer1
Details
This trigger model template allows you to sort components and place them into up to four bins, based
on the comparison to limits.
To set a limit as unused, set the high value for the limit to be less than the low limit.
All limit patterns and the all fail pattern are sent on digital I/O lines 1 to 4, where 1 is the least
significant bit.
After selecting a trigger model template, you can view the trigger model blocks in a graphical format
by pressing the front-panel
MENU
key and under Trigger, selecting
Configure
. You can also add or
delete blocks and change trigger model settings from this screen. You can use the
trigger.model.getblocklist()
command to view the trigger model blocks in a list format.
Also see
None
trigger.model.setblock() — trigger.BLOCK_BRANCH_ALWAYS
This function defines a trigger model block that always goes to a specific block.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Restore configuration
Instrument reset
Power cycle
Configuration script
Not applicable
Usage
trigger.model.setblock(
blockNumber
, trigger.BLOCK_BRANCH_ALWAYS,
branchToBlock
)
blockNumber
The sequence of the block in the trigger model
branchToBlock
The block number to execute when the trigger model reaches the Always block