Model 2461 Interactive SourceMeter® Instrument Reference Manual
Section 6: SCPI command reference
2461-901-01 A/November 2015
6-139
:STATus:QUEStionable:MAP
This command queries mapped event numbers or maps event numbers to bits in the event registers.
Type
Affected by
Where saved
Default value
Command and query
Not applicable
Not applicable
0
Usage
:STATus:QUEStionable:MAP <bitNumber>, <setEvent>
:STATus:QUEStionable:MAP <bitNumber>, <setEvent>, <clearEvent>
:STATus:QUEStionable:MAP? <bitNumber>
<bitNumber>
The bit number that is mapped to an event (0 to 14)
<setEvent>
The number of the event that sets the bits in the condition and event registers; 0 if
no mapping
<clearEvent>
The number of the event that clears the bit in the condition register; 0 if no mapping
Details
You can map events to bits in the event registers with this command. This allows you to cause bits in
the condition and event registers to be set or cleared when the specified events occur. You can use
any valid event number as the event that sets or clears bits.
When a mapped event is programmed to set bits, the corresponding bits in both the condition register
and event register are set when the event is detected.
When a mapped event is programmed to clear bits, the bit in the condition register is set to 0 when
the event is detected.
If the event is set to zero (0), the bit is never set.
See
(on page C-10) for information about event numbers.
When you query the mapping for a specific bit, the instrument returns the events that were mapped to
set and clear that bit. Zero (0) indicates that the bits have not been set.
Example
:STAT:QUES:MAP 0, 4916, 4917
When event 4916 (the buffer is 0 % filled)
occurs, bit 0 is set in the condition register and
the event register of the Questionable Event
Register. When event 4917 (buffer is 100 %
filled) occurs, bit 0 in the condition register is
cleared.
Also see
None