Page 16
DOC1049R (22 February 2024 12:07)
www.keit.co.uk
Back to Table of Contents
Figure 15: High flow cell fitted to IRmadilloNA probe
Table 1
– Specifications and safety limits (high flow cell)
Parameter
High Flow Cell
Pressure
Refer to high flow cell marking
Analyte Temperature
Refer to high flow cell marking
Body Material
Corrosion-resistant metal
O-ring Seal
FFKM (Kalrez)
Port Size
3/4” NPT
Cell Internal Volume
~27 ml
Intended Use
Only for use with ASM0627-09-N-Cx-O-Gx-D3x
Fluid Group
1
Minimum Inspection Frequency
Annual
4.2.2. Low flow cell - ASM1222
The low flow cell that can be secured to the end of the probe for continuous analysis of your
process. The flow cell is
equipped with two 1/16” NPT fittings to attach pipelines too, or it can
be assembled
with two ¼” Swagelok nuts attached to a short section of pipe on opposing
sides. It is designed to force liquid past the ATR and is primarily used for lab work where flow
rate and volume are low.
It is fixed in place using a tri clamp that locates over the rear of the flow cell and two semi-
circular collars
‘C-pieces’ that fit around the probe. Ensure that the C-pieces make good
contact with the probe and that the pins are seated inside their corresponding holes. Slide the
