08
AIR300 LEG EXTENSION PRO
|
OPERATION MANUAL
INSTALLATION AND PLACEMENT
TRAINING SPACE
Figure 4. Training Space for the Air300 Leg Extension Pro
The equipment footprint is 40 inches x 39 inches (1,016
mm x 991 mm).
The minimum recommended free space around the
equipment is 24 inches (610 mm) for the front and
sides.
ASSEMBLY AND PLACEMENT
No assembly required. Place the Air300 Leg Extension
Pro on a flat, level surface. Make sure the base of the
frame makes full contact with the floor. If gaps are
present, relocate the equipment to an even surface.
CONNECT THE EQUIPMENT TO THE KEISER AIR
SYSTEM
WARNING: Never connect equipment to an air
source capable of exceeding 120 psi / 8.27 bar.
Over pressurizing Keiser pneumatic equipment may
cause tubing to burst, breakage of equipment,
abnormal operation, or serious injury. Use only clean,
dry, regulated compressed air at the rated pressure
range of 100–120 psi / 6.89–8.27 bar.
1. Plug the Compressor into the appropriate power
source to power the Compressor ON
(allow the
Compressor to build up to a minimum of 100 psi / 6.89
bar; Keiser Compressor and Keiser Air System not
included, sold separately)
.
2. Connect the 1/4-inch Quick Disconnect (QD) from
the equipment into the Keiser Air Supply
(see
Figure 3)
.
Note: Additional Free Space may be required to accommodate mobility device access.
Figure 3. How to Connect the Equipment to
the Keiser Air Supply
Keiser Air System
(floor or wall air outlet)
Direct-connect to
Keiser Small Air Compressor
Keiser
Large Air Compressor
Keiser
Small Air Compressor
1/4-inch QD
FREE AREA
24 inches
(610 mm)
24 inches
(610 mm)
24 inches
(610 mm)
FOOTPRINT
39 inches
(991 mm)
40 inches
(1,016 mm)
T-88 THRUST BEARINGS BREAK-IN NOTICE
(new installation only)
The T-88 Thrust Bearings on the exercise arms of this machine may wear slightly during the first
3 - 5 weeks of use. Check the exercise arms weekly for proper adjustment during this period.
Scan the QR code for the “T-88 Thrust Bearings Adjustment” procedure.
NOTE: Bearings may seep a small amount of grease during break-in and is normal during this
period. If this occurs, wipe off exposed grease daily. After the break-in period, the grease seepage
will stop.
