T-506 User Manual Version 3.2 | 31
Where the instrument is not used on a regular basis, it should be stored indoors using the
original packaging, and should not be exposed to the sun or rain. The room should be air-
conditioned and should not contain corrosive gas. The instrument should not be subjected
to severe mechanical vibration or shock and there not be a strong electromagnetic field.
If the instrument is not used for a long time, make sure that the detector and tablet are
turned off and fully charge them every 10 months.
8.
Instrument charging
Always use the dedicated charger with the detector. Insert the charger plug into a
220V/50Hz AC (or 110V/60Hz) power socket, and insert the output plug into the T-506
detector charging socket. The detector takes 3 hours from being completely discharged to
full charge. This process is automated and requires no intervention.
Use the tablet charger provided and always use its charger when re-charging.
9.
Unpacking and inspection
Before unpacking for the first time, follow the steps below.
i)
Take out the document bag containing the instructions and packing list.
ii)
Check the packing list to ensure that the contents are complete and intact.
iii)
Check that the serial number is consistent with the instrument and the factory
number of the warranty card.
iv)
Check the power-on to make sure the detector and tablet are functioning properly.
10.
Maintenance and troubleshooting
10.1
Daily maintenance
As long as it is used properly, the instrument does not have any parts that require
maintenance or calibration under normal conditions. If the surface of the instrument
(including probe, handles, tablets, tablet holders, and headphones) is contaminated with
dirt, wipe it off with a soft, dry cloth or a soft cloth slightly dampened with a soft (non-
bleach) household cleaner.
As a basic principle, do not let moisture into the detector charging port or the tablet; if the
surface of the detector unit or tablet becomes wet, dry it with a soft cloth.
Take care not to insert the power -plug in to the tablet headset socket or data cable
interface and do not pull the headset cable too hard.
As a basic principle, mainframes, tablet PCs, headsets and other accessories should avoid
strong vibrations and shocks.
