HIZO G14 Pizza Oven
–
User Manual
Page
5
of
12
Last Updated 19/07/2022 3:47 PM
LPG GAS CYLINDER AND HOSE REQUREMENTS
Do not use an LPG cylinder which exceeds the following dimensions:
•
max diameter - 390mm
•
max height - 455mm
The supply hose for the appliance should not exceed 1.5m
Ensure the gas supply tubing or hose complies with the national
requirements in force and is periodically examined and replaced as
necessary.
The hose should comply with the standard EN16436. The regulator
should comply with the standard EN16129.
Position any flexible gas supply hoses to ensure that they are not
subjected to any twists or kinks.
LPG GAS CYLINDER WARNINGS
1.
Do not store spare liquid propane gas cylinder under or near this appliance.
2.
The cylinder used must include a collar to protect the cylinder valve.
3.
Never fill the cylinder beyond 80 percent capacity.
4.
Liquid propane cylinder must be fitted with an OVERFILL PROTECTION DEVICE (OPD).
5.
If the information above is not followed exactly, a fire resulting in death or serious injury
may occur.
BEFORE LIGHTING
Inspect the gas supply hose prior to turning on the gas. If there is evidence of cut, wear or abrasion,
it must be replaced prior to use.
Check and clean the inside of the oven before it is lit to avoid ignition of any oils left over from the
previous cook. Also check the burner outlets for any obstruction which may have resulted from the
previous cook. The burner outlets should be checked for obstruction and cleaned regularly with a
soft wire brush, this is necessary to avoid obstruction and to allow for a good combustion.
Screw the regulator onto the gas cylinder. Leak check the hose and regulator connections with a
soap and water solution before lighting the appliance.
MODEL
HIZO G14
Injector size
1.11 mm
Calorific value
14000 BTU
Type of gas
Propane
Gas pressure
28 mbar
