KegMaster
™
XL User Manual
Page 8 of 18
Keg King is a registered business name of MCH Australia Pty Ltd
Door Orientation
The KegMaster
™
XL door is reversible. It can be removed and re-attached to swing from the left or right,
depending on your preference. If you wish to change the door orientation:
1.
If the KegMaster
™
XL unit is powered on, turn off the power and unplug it.
2.
Prepare a soft towel or blanket for resting the KegMaster
™
XL on its back.
3.
To get access to the underside of the KegMaster
™
XL, carefully tip it onto its back,
resting it on the prepared soft towel or blanket.
4.
Unscrew the
Leveling Foot
(4), which should be on the opposite side to the
Door Hing
Bracket
(5).
5.
Remove the
Door Hinge Bracket
(5) by unscrewing the 2 bolts holding it in place.
6.
Carefully slide the door approximately 10cm away from the upper hinge.
7.
Remove the
Hinge Pin
(6) from the top corner of the door or unit.
8.
Insert the
Hinge Pin
(6) in the hole in the opposite top corner of the door.
9.
Slide the door back into place, ensuring that the
Hinge Pin
inserts into the retaining hole
in the opposite top corner of unit.
10.
Fit the
Door Hinge Bracket
to the opposite bottom corner of the door.
11.
With the
Door Hinge Bracket
attached to the door, use the removed bolts to fasten the
Door Hinge Bracket
onto the opposite side of the unit, and tighten firmly.
12.
Attach the
Leveling Foot
(4) where the
Door Hinge Bracket
was previously.
13.
Tip the KegMaster
™
XL unit back to the upright position.
14.
The KegMaster
™
XL will need to rest upright for 24 hours before power is reapplied.
WARNING
DO NOT power up the refrigeration unit until it has rested upright for 24 hours.
Failure to do so will void the Warranty!
