As fun as homebrewing is, it presents cer-
tain hazards to the environment due to the
presence of hot liquids, electricity, heavy
lifting and the use of cleaning agents. It
is important to brew in clean, safe condi-
tions, maintain your brewery equipment
and store chemicals properly.
• Make sure that your Nanobrewery is
sitting on a flat, horizontal surface during
operation.
• Ensure that the pump is turned off and
that the ball valve is connected to the ket-
tle body tightly and in the closed position
(handle is perpendicular to the outlet) be-
fore filling.
• Always brew in a well-ventilated area
with drainage zones.
• Keep away from children and pets
during operation.
For your own safety, please read the in-
structions carefully and keep this manual
for future reference. This is an electronic
device so handle with care.
• If the power cord is damaged, do not
use the main vessel. Call a licensed tech-
nician to replace the power cord.
• Do not connect any power adaptors to
the main vessel as they can be potentially
damaged by high wattage.
dry may cause damage to its internal com-
ponents.
• Check your power supply before plug-
ging in the power cord (10A for 40L and
15A for 50L). Failure to do so may lead to
overloading which can damage the wiring
on your Nanobrewery.
• If you are using an extension cord with
your Nanobrewery, ensure no other prod-
ucts are connected to the extension cord.
• Do not wet the outside of your Guten
when it is switched on. Doing so will in-
troduce moisture and potential damage to
the display panel and switches.
• Make sure that there is water inside
the Guten before heating or turning on the
pump. Running the Nanobrewery
• Make sure that the Nanobrewery is
turned off and unplugged if you are clean-
ing and rinsing the exterior surfaces.
Brew Vessel
This is the very heart and soul of the Guten
Nanobrewery. With an in-built heating ele-
ment, pump and control panel, the brew
vessel houses all of the attachments and ac-
cessories to forgo brewing and even cook-
ing. A ½’’ BSP ball valve is also attached
to the side for wort transfer and sampling.
Malt Pipe Assembly
The Malt Pipe Assembly is used during
the mash. It sits right inside the brew ves-
sel and houses the grains. The assembly
itself comprises of a malt pipe, an over-
flow telescope with ½’’ BSP fittings, a top
screen and a locking bottom screen.
3. Parts List
2. Safety Instructions
