Keenon Robotics DINERBOT T8, User Manual, Page: 11 / 36

9
Maintenance
5.1 Cleaning
Sensor
Wipe the robot sensor with a soft, dry cloth.
- Wipe the surface and interlayer of the radar (refer to Section 3.1
⑥
LiDAR for the position)
- Gently wipe the stereo vision sensor area in the same direction (refer to Section 3.1
⑤
stereo
vision sensor for the position)
- Gently wipe the image positioning module in a clockwise direction (refer to section 3.1
①
image
module for the position)
Exterior surfaces and tray
1. Soak a piece of cloth with water, wring it out, and wipe the outer surface of the machine and
the tray; if there is oil stain that is hard to be wiped off with a damp cloth, try wiping it with
alcohol.
2. Then, wipe the outer surface with a dry cloth.
Wheels
1. Place the robot on its side on a fl at surface covered with a soft protective pad.
2. Take down the omni-directional wheels to remove hair and dirt from the wheels, and wipe with
a damp cloth.
3. Assemble the wheels and lock them securely.
*Disassembly and assembly of the machine should be performed by professionals, otherwise the
robot may be damaged.
Battery
- For battery maintenance, you must contact our company's professionals for after-sales
maintenance and replacement.
- When the robot is not used for a long time, it must be charged every three months to avoid
battery damage.
5.2 Transportation
Please strictly follow the instructions below if moving the robot manually is necessary to prevent
damage to the machine.
CAUTION
Before cleaning the device, Ensure you turn off its power and unplug the power cord from the
power outlet.
When wiping the exterior surfaces and cabin interior to remove oil stains with alcohol, benzene,
or any other
fl ammable cleaners, caution should be taken to use a damp cloth afterwards to
prevent cleaner from seeping in, which could result in fi re or electric shock.
CAUTION
This product is an electronic product. Please keep transportation safety in mind when
transporting.