Kedacom IPC427-D020-N, User Manual

Page: 21 / 53

HD IR Dome Camera User Manual
17
Preset point speed level : the speed to load preset position, the larger the value is, the faster the speed is;
otherwise, the speed is slower.
Zoom Speed Level : the speed level of focusing, the larger the value is, the faster the speed is.
Enable Auto PT Speed : check this option and the auto PT speed function will be enabled, i.e. the dome
camera changes according to the zooming factor of PTZ control automatically. When it zooms in, the dome
camera moves slower automatically; when it zooms out, the dome camera moves faster automatically.
PTZ position display format : support display according to azimuth angle or PT position.
Tilt Angle Range : the rotation angle range in tilt direction, -15° ~ 90°.
Last Spot Recovery
Check it to enable last spot recovery function.
Last Spot Recovery : Before the dome camera is powered off, it stays at a position for a certain period of time
and this position is remembered by the system. When the camera is powered again, it can restore to the
position before powering off. If the stay time of the camera at the last spot before powering off is shorter than
the specified time, it will recover to the last but one position when being powered again.
Recovery Mode: select Last Spot Recovery from the dropdown list and set Recovery Time. Click
“Save”.
Load Preset When Power On : when the dome camera is powered off and powered on again, it will recover to
the set preset position directly. Select Load Preset When Power On in the dropdown list of Recovery Mode,
and choose a preset No., and click
“Save”.
Picture 4-5 Basic Config
4.2.2 Guard Tour
Guard Tour means the dome camera can perform preset operations if not receiving any command in a specific
period of time (i.e. the Waiting Time in the setting interface). After stopping PTZ operations for a certain period
of time, user can enable the Guard Tour function.