1
Introduction
1.1
Purpose of the document
This document describes the structure, installation and connection of the op-
erating panel OP 350/C-1100.
1.2
Target groups, pre-conditions
This document is intended for the following persons with corresponding pre-
conditions:
Target group
Prerequisite knowledge and ability
Project engineer
Technical basic education (advanced technical education, engineering
degree or corresponding professional experience),
Knowledge about:
●
the method of operation of a PLC,
●
safety regulations,
●
the application.
Start-up technician
Technical basic education (advanced technical education, engineering
degree or corresponding professional experience),
Knowledge about:
●
safety regulations,
●
the method of operation of the machine or system,
●
fundamental functions of the application,
●
system analysis and troubleshooting,
●
the setting options at the operating devices.
Service technician
Technical basic education (advanced technical education, engineering
degree or corresponding professional experience),
Knowledge about:
●
the method of operation of a PLC,
●
safety regulations,
●
the method of operation of the machine or system,
●
diagnosis possibilities,
●
systematic error analysis and troubleshooting
1.3
Intended use
The operating panel is designed for complex operating tasks in the industrial
sector in conjunction with a control of the Kemro K2 product family from the
KEBA AG. The typical applications areas include injection molding machines,
robots, presses, machine tools. The operating panel may only be used for the
applications described here.
The operating panel was developed, manufactured, tested and documented
in accordance with the appropriate safety standards. Therefore, the products
Operating panel
Introduction
© KEBA 2009
Project engineering manual V2.00
7
Summary of Contents for Kemro OP 350/C-1100
Page 4: ......