7
Operation and handling
7.1
Removing the display protective film
1) Loosen the protective film from the display at a corner.
Fig.7-1:
Detailed diagram 1: Remove the protective film
2) Pull off the film at an angle of approx. 180° (see following image).
Fig.7-2:
Detailed diagram 2: Remove the protective film
Information
On operating panels with touch screen, the protective film may not be pulled
off upwards at an angle of 90° because this will lead to an unallowed me-
chanical loading and possible damage of the touch screen.
After the protective film has been pulled off, it should not be applied again to
the display since it can no longer adhere evenly.
7.2
Software
7.2.1
Software
No application has been stored in the operating panel. It is activated directly
through the control system. The device will not trigger any error messages.
It is possible to perform firmware updates.
Operation and handling
OP 350/C-1100
© KEBA 2009
Project engineering manual V2.00
34
Summary of Contents for Kemro OP 350/C-1100
Page 4: ......