1.3
Intended use
The NX 252/A may only be used for the types of use described in the technical
descriptions and only in conjunction with recommended/approved third-party
equipment/installations.
The NX 252/A has been developed, manufactured, tested and documented in
accordance with the appropriate safety standards. Therefore, the products do
not pose any danger to the health of persons or a risk of damage to other
property or equipment under normal circumstances, provided that the instruc-
tions and safety precautions relating to the intended use are properly observed.
1.4
Notes on this document
This manual is integral part of the product. It is to be retained over the entire
life cycle of the product and should be forwarded to any subsequent owners
or users of the product.
1.4.1
Contents of the document
●
Description of the Ethernet PCI option module NX 252/A
●
Use of the Ethernet PCI option module in CPU modules
●
Description of interface including EMC measures
●
Technical data
1.5
Documentation for further reading
The following documents are to be observed depending on the system solution
used:
If you are using the KeStudio U2 tool suite:
Doc.No.
Name
Target group
DE: 65352
EN: 65353
K2-200 automation system manual
●
Project engineer
●
Electrician
●
Programmer
●
Commissioning foreman
●
Service technician
If you are using the KeStudio U3 tool suite:
Doc.No.
Name
Target group
DE: 1000868
EN: 1000869
System manual Kemro automation
system
●
Project engineer
●
Electrician
●
Programmer
●
Commissioning foreman
●
Service technician
Introduction
NX 252/A
© KEBA 2011
Project engineering manual V1.03
8
Summary of Contents for Kemro NX 252/A
Page 4: ......
