CP 503/A, CP 505/A,D,K, CP 507/
A,C
Mounting and installation instructions
Project engineering manual V1.06
30
© KEBA 2021
Fig. 5-14: Dismantling from the mounting rail
To dismantle the module, proceed as follows:
1) Disconnect the power supply.
2) Disconnect all cable connections on the module.
3) Remove the end bracket.
4) Release all of the mounting rail locks one after the other (
1
).
5) Tilt the lower part of the module to release it from the mounting rail (
2
).
6) Remove the module from the mounting rail (
3
).
The module is dismantled.
5.7
Adding modules
Input/output modules and expansion modules can be added to the CP 50x/x.
The CP 50x/x provides the supply output for the appended modules. On the
left side of the module, up to 4 expansion modules can be added. The con-
nection between CP 50x/x and the added expansion modules is made via a
plug connection.
Input/output modules are supported on the right side of the module. They
can be arranged side-by-side in any order. The connection is made via a Ke-
Bus interface.
