KEB COMBIVERT F5, Reference Manual

Page: 72 / 349

72
TTL Incremental SubD - Encoder Connections
3.3.8 Incremental TTL
Encoder Interface X3A
SubD Connect the incremental encoder mounted on the motor to the 15-pin
Sub-D connector at X3A. This connection provides speed feedback and is
imperative to the proper operation of the F5.
Encoder Card Part Number: Housing Siz e ≤ E, 1MF5K81-DZ19. Housing
Size ≥ G 2MF5K81-DZ19.
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
5.2 V x I
+5V
I
var
= 170 mA - –————
V
var
The internal voltage of "V
var
" 24...30 V is
an unregulated supply and will allow up
to 170 mA max. current draw, for X3A and
X3B total. If higher voltages/currents are
required, then an external power supply
must be provided.
The +5.2 V is a regulated voltage supply
generated from V
var
and will allow up to
500 mA max. current draw, for X3A and
X3B total. If additional current is required
from the +5.2 V output, the current from
V
var
decreases in accordance with the
following formula:
The following specifications apply to encoder interface X3A and X3B, channel 1
and 2, respectively:
• Max. operating frequency: 300 kHz.
• Internal terminating resistance: R
t
= 120 Ω
• RS422 or TTL level square wave
voltage level: 2...5 Vdc
ONLY when the inverter is switched off and the voltage
supply is disconnected may the feedback connectors be
removed or connected!

Input Wiring
A +
B +
A -
B -
approx.
120
Ω
approx.
34
Ω
Pin No. Signal
3 A-
4 B-
8 A+
9 B+
11 V
var
24...30 V
12 +5.2 V
13 0V (com)
14 N-
15 N+
Shield Housing