KEB COMBIVERT F5-A, Applications Manual, Page: 501 / 552

Network components
© KEB, 2012-10 COMBIVERT F5-A, -E, -H Page 10.1 - 5
10
10.1.5
Profibus-DP operator F5 00.F5.060-3000
The PROFIBUS-DP interface module realizes a passive user (Slave). This means that the PROFIBUS-DP
interface module only transmits, if it receives an enquiry for that from the master.
The PROFIBUS-DP protocol defines different operating conditions, that must be executed first, before the ac
-
tual user data can be exchanged. The responsible DP master must first parameterize and then configure his
slaves. If these two functions are successfully completed, the cyclic exchange of user data begins.
Fig. 11.1.5 Profibus-DP operator
ANTRIEBSTECHNIK
START
STOP
FUNC.
SPEED
ENTER
F/R
PBS1 PBS2
ANTRIEBSTECHNIK
Diag
E
PAR
PDOUT
PDIN
PAR (green): Parameterizing channel
active
PDOUT (green): PDOUT data are written to
the FI control
PDIN (green): PDIN data are read by the
FI control.
E (red): On ==>
Blinking ==>
off ==> Inverter ready for operation
Inverter failure
No supply voltage
Diag: Diagnostic interface to the
PC
PBS1: PROFIBUS-DP interface
(socket connector)
PBS2: PROFIBUS-DP interface
(pin-connector)