KEB COMBIVERT F5-A, Applications Manual, Page: 426 / 552

Page 7.14 - 8 COMBIVERT F5-A, -E, -H © KEB, 2012-10
Parameter sets
7.14.7 Select parameter sets
Figure 7.14.7 Principle of the parameter set selection
Fr.2
0
1
2 3
2
0
2
1
2
2
1 2 3 4 5 6 7 1 2 3 4 5 6 7
4
5
digital
set selection deacti-
vated
set 0 always active
Fr.4 via
keyboard/bus
terminal strip
binary coded
terminal strip
binary coded
ST>RST>...>ID
terminal strip
binary coded
ID>IC>...>ST
SY.50 with
control word
(only bus)
Parameter set 0...7
Fr.3 Parameter set lock
Set 0...7 (Value 0...255)
Is
selected set
locked ?
yes
no
Actual Parameter set
Error message
E.SEt
ATTENTION! The valency at Fr.2
= 2...4 is generally ID > IC > ...>ST.
The sequence above refers to the
priority.
Fr.02 Source parameter set
As shown in Fig. 7.14.7 it is defined with Fr.02
whether the parameter set selection is enabled or disabled via
keyboard/bus (Fr.04), terminal strip or via control word (SY.50). The selection is activated with „Enter".
Fr.02: Parameter set source
Value Function
0 Set selection deactivated; set 0 always active
1 Set selection via keyboard/bus with Fr.4
2 Set selection binary-coded via terminal strip
3 Set selection input-coded via terminal strip
Priority: ST>RST>R>F>I1>I2>I3>I4>IA>IB>IC>ID
4 Set selection input-coded via terminal strip
Priority: ID>IC>IB>IA>I4>I3>I2>I1>R>F>RST>ST
5 Set selection via control word SY.50
Fr.04 Adjustment parameter set