KEB COMBIVERT F5-A, Applications Manual, Page: 421 / 552

Parameter sets
© KEB, 2012-10 COMBIVERT F5-A, -E, -H Page 7.14 - 3
7
7.14 Parameter sets
The KEB COMBIVERT contains 8 parameter sets (0...7), i.e. all programmable parameters are available 8
times in the inverter and independent of each other they can be assigned with different values. As a lot of
parameters in the parameter sets contain the same value, it would be relatively complicated to change every
parameter in each set individually. In this section it is described, how one copies whole parameter sets, locks
them, selects them and reinitializes the inverter.
7.14.1 Non-programmable parameters
Certain parameters are not set-programmable, since its value must be equal in all sets (e.g. bus address or
baud rate). For an easy identification of these parameters the parameter set number is missing in the parameter
identification.
For all non-programmable parameters the same value is valid independent of the selected parameter
set!
Following parameters are non-programmable:
Sy-Parameter Pn.00...18/ 23/ 27/ 29/ 42/ 44...60/ 62...66/ 68/ 69/ 74…81
ru-Parameter uF.08/ 12...15/ 18 (uF.09 at F5-S) / 18…23
Ec parameters ud.01...17/ ud.22…31 (all at F5-S)
AA-Parameter Fr.02...04/ 07/ 09/ 11 (Fr.10 at F5-S)
di-Parameter An.00...04/ 10...14/ 20...24/ 41...56
In-Parameter (exception: In.25) LE.16-27
dr-Parameter (not at F5-S) cn.03/ 11...13
oP.19/ 20/ 50/ 53...58/ 60…63/ 65…68/ 74 dS.00...01 (only F5-S)
PS.02...04/ 10...27/ 29...31
7.14.2 Security parameters
The security parameters contain the Baud rate, inverter address, hours/meter, control type, serial-/customer
number, trimming values and error diagnosis. They are not overwritten while copying parameter sets from the
default set.
Sy.02/ 03/ 06/ 07/ 11
ru.40/ 41
ud.01/ 02
Fr.01
In.10...16/ 24...31
7.14.3 System parameters
The system parameters contain the motor and encoder data.
dr-Parameter Pn.61/ 67
cS.00...19...22 dS.00...01/ 13
Ec.01...07/ 11-27/ 36...38 Fr.10