KEB C6 E22 BM-RVL, Instructions For Use Manual

Page: 42 / 114

42
INSTALLATION AND CONNECTION
3 Installation and connection
3.1 Preparation for installation
3.1.1 Select the mounting location
• Avoid direct sunlight ex-posure.
• Make sure that C6 E22 BOX/PANEL is properly (ergonomically) accessible to the
operator.
• Choose a suitable mounting height.
• Ensure that the aeration holes are not covered.
3.2 Checking the package contents
• Check the package content for visible signs of transport damage and for complete-
ness.
• In the case of damaged parts, contact your KEB representative. Do not install parts
that were damaged during the shipment.
3.3 Checking the operating conditions
• Read carefully the standards, approvals, EMC parameters and technical specifi -
cations for operation of the device. This information is available in the following
sections:
a) Certificates and approvals.
b) Electromagnetic compatibility.
• Check the mechanical and climatic ambient conditions for operation of the device.
Follow the instructions for use of the device.
• Adhere to the permissible rated voltage and the associated tolerance range:
3.4 Mounting
In general, C6 E22 BOX/PANEL device is suitable for installation in several mounting
conditions, such as:
• Mounting cabinets
• Control cabinets
• Switchboards
• Consoles
However, some important mounting rules must be followed, in order to avoid thermal
and mechanical problems.
WArNING
for installation in control cabinets and in particular, in closed con-
tainers, make sure the ambient tem-perature complies with the re-
quirements !