KE LOGEM 928, Operation Manual

Page: 93 / 200

93
Operation Manual V.34 - Modems, Version 07/97
AT
Chapter 3
AT\K(n) BREAK Handling
The command controls the BREAK signal handling and is not applicable
during direct mode.
command parameter/default description
AT\K(n) 0...3 / 3 BREAK handling
0 ignore BREAK
1 erase data buffer, transfer BREAK
2 transfer BREAK immediately
3 transfer BREAK with transmit/
receive data
3.8 Handshake
AT\G(n) Data Flow Control
The command controls the data flow between local and remote modem.
command parameter/default description
AT\G(n) 0, 1 / 0 data flow control
0 no data flow control
1 XON/XOFF data flow control, the mo-
dems are no longer transparent if
AT\G1 is selected
AT\Q(n) Select Flow Control
The command defines the flow control procedure to be utilized between
DTE and modem. Flow control is not applicable for direct mode operation.
Data flow control is employed whenever DTE and line rate have any
differences or when the data flow has to be stopped for block
retransmissions during error controlled mode. You can either employ
hardware flow control (RTS/CTS) or software flow control (XON/XOFF).
command parameter/default description
AT\Q(n) 0...3 / 2 select flow control
0 no flow control
1 XON/XOFF flow controll
2 RTS/CTS flow control with S2/105
and M2/106
3 flow control with XON/XOFF and
S2/M2
AT Commands