KE LOGEM 928, Operation Manual

Page: 101 / 200

101
Operation Manual V.34 - Modems, Version 07/97
AT
Chapter 3
be saved with AT&W(n). The connection is terminated with an ATZ(n)
command and the new configuration is loaded. If you do not type the
ATZ(n) command the remote modem keeps the latest settings until the
next POWER ON.
Attention: As remote configuration is only applicable for reliable
mode the commands ATF(n) (n= 4 or 5) and AT\N1
prevent further remote accesses!
Remote modem configuration is possible even with any other external
modem just by transmitting a BREAK signal in transparent mode. Then
you have to type the configuration password within10 secs. terminated
with a carriage return (CR). Successful initiation of remote configuration
is indicated by a %OK report.
3.12 Loudspeaker
Attention: The commands decribed below are only valid for the
standalone modem LOGEM
® 928.
ATL(n) Loudness
The built-in loudspeaker can be set in three different stages.
command parameter/default description
ATL(n) 0...2 / 1 loudness
0 low
1 medium
2 high
ATM(n) Loudspeaker Setting
The loudspeaker can be adjusted to control establishment of connections.
command parameter/default description
ATM(n) 0...2 / 1 loudspeaker setting
0 loudspeaker OFF
1 ON during dialing and dial up
2 constantly ON
AT Commands