KDF Cascom SE, Instruction Manual, Page: 7 / 22

- 5 -
Descriptions of Component Parts ■
Main Parts and Descriptions
●
（ ） （ ）
Front View Back View
Operation Panel Panel to operate a casting process.
Pressure Gauge Indicates pressure inside of the muffle chamber.
Lock Arm Used to lock the chamber lid and seal the muffle chamber.
Power Switch with 20A breaker. In case of eddy current, shut it down immediately.
Dust Proof Filter Used to prevent dust from entering the unit.
Muffle Chamber Used to house furnace muffle to heat up and melt casting alloys.
Chamber Lid Handle Used to manually open and close the chamber lid.
Note) Be gentle when you open and close the chamber lid. Quickly repeated movement will cause damage
to the unit.
View Glass Used to protect eyes when checking melting alloy.
Vacuum Filter Used to prevent dust in the chamber from entering the unit.
Eyebolt Used to prevent the unit from falling down. Tie down the unit.
Air/Argon Switch Knob Manual switch knob to choose between pressurized air or argon gas in applying
pressure for casting.
Compressed Air Filter Used to prevent rust, dust, moisture etc. out of compressor from entering the unit.
Periodic cleaning is recommended.
Drain Cock Cock to drain the moisture in the internal air tank.
Exhaust Filter This is the exhaust filter of vacuum unit.
Operation panel
Air/Argon Switch Knob
CHILLER OUTLET CHILLER
SIGNAL
ARGON
0.5-1.0MPa
WATER A WATER B
AIR IN
0.5-1.0MPa
DRAIN COCK
View Glass
Chamber Lid
Handle
Muffle Chamber
Dust Proof Filter
Power Switch
Lock Arm
Pressure Gauge
Drain Cock
Vacuum Filter
Eyebolt
Eyebolt
Compressed Air Filter
Exhaust Filter
EXHAUST
FILTER