Adjust the lock plate
The spring preload of the rear shock can be controlled by
adjusting the lock plate. Adjust the lock plate downward, the
spring preload increases; Adjust the lock plate upward, the
spring preload is reduced.
Check the setup of the front shock
The measurement procedure is as follows:
1.Place the whole motorcycle on the ground.
2.Righten the motorcycle.
3.Hold the handlebars with both hands and press down the front shock.
4.Observe the effect of reduction and rebound.
Adjust handlebar
The handlebars of the motorcycle can be adjusted according to
customers' riding habits. The specific steps are as follows:
1.Remove the pad and cover from the handlebar.
2.Unscrew the press bolt so that the handlebar can rotate.
3.Sit on the motorcycle and adjust the handlebars to the natural
position of your hands.
4.Tighten the press bolt
5.Check the handlebar position, if not satisfied, repeat the
above process.
Maintenance
Placement of motorcycle
