2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Page no. 50 | Appendix
9
Appendix
9.1
Lens Mount Installation Manual
The following lens-mount installation instructions are for LUX19/ LUX160 SENSOR QSFP+/Dual SFP.
1.
Position the camera in a position that will allow
comfortable access to the screw holes. Prepare
the lens mount in advance. As the sensor/filter,
remain exposed during the process-working make
sure to work in a clean environment – preferably a
clean room or at least a fume-hood.
!
Figures 1 to 5 depict an F-mount but the
installation process is identical for all mounts
offered by KAYA Instruments.
Figure 46 – JetCam front panel and the lens mount
2.
Align the screw-holes on the mount with the ones
on the camera’s front panel.
Figure 47 – Positioning the mount over the front panel
3.
Using a pair of tweezers position four M2.5x4
black-coated screws in the screw-holes.
Be very
careful to not accidently drop a bolt on the imaging
sensor. Do not lift a bolt before making sure it is
firmly gripped.
Start by screwing all four of screws the about
halfway in and proceed by fully screwing them in a
cross-diagonal pattern (e.g. top-left, bottom right,
bottom left and then top right).
Figure 48 – Carefully handle the screws to avoid scratches
