2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Page no. 47 | CLI Interface
8.3
Optional peripheral add-ons
The JetCam can be connected to a Canon Birger lens control module that can be purchased and that can be
controlled using JetCam's virtual communication port. Here is a brief explanation on how to perform the
connection and use Birger's lens control:
1.
Power down the camera.
2.
Connect the Birger adaptor to the Canon lens and to the camera via the GPIO connector.
Connect the fiber cables and the USB cable and power up the camera.
Figure 41 – Camera with optional Birger adaptor
3.
Open Vision point software and detect the camera.
4.
After the camera was detected, under "Cameras" -> "Device Control" -> Serial Port Selector" select "RS232 0"
and set the "Serial Port Baud Rate" to 115200.
Figure 42 – Serial port setup at camera side
