Kaya Instruments IRON CoaXPress, User Manual

Page: 38 / 43

2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
www.kayainstruments.com Page no. 35 | Configuration Interface
6.10 Test Control
Test Control category contain parameters for camera testing and analysis purposes only. These configurations
are not required for standard operation of the camera.
Configuration of these parameters might result in unexpected camera behavior if wrong value is input.
Figure 23 – Test Control parameter configuration in GenICam Browser
6.10.1 Test Control XML Parameters
Parameter Description Gen<i>Cam name Type Possible values Remarks
Value Gen<i>Cam name
Gen<i>Cam Category: TestControl
Sensor Register
Address Sensor Register Address SensorRegAddress Integer
Sensor Register
Value Returns the value of sensor
register at SensorRegAddress
address SensorRegValue Integer
Gen<i>Cam Category: TestControl/BIT
BIT Reset All Reset all BITs BITResetAll Command 1 - Activate
BIT Start All Start all BITs BITStartAll Command 1 - Activate
BIT Count Number of available BITs BITCount Integer
BIT Selector
Index Selects BIT configuration BITSelectorIndex Integer
(Selector)
BIT Selector Selects BIT configuration BITSelector Enumeration 0 Flash
1 Uart
2 SensorControl
3 SensorLVDS
4 Temperature
5 Voltages
6 MACOM
7 GPIO