KaVo ORTHOPANTOMOGRAPH OP 3D Pro, Installation Manual

Page: 34 / 168

3 Pre-installation requirements
26
3.3 Fixing hardware and Installation and
Setup tools
The following tools and hardware are required to install and
set up the unit. These are not included in the delivery of the
unit, unless otherwise stated.
Fixing hardware
NOTICE! Mounting bolts for floor and wall fastening are not
included in the delivery.
The type and length of hardware to be used depends on
the wall material and floor material to which the unit is to be
attached.
Installation tools
- Electric drill
- Spanners (wrenches) 10, 17 (x 2) mm AF
- Allen keys (Hexagon socket wrenches) 1.5-8mm
- Flat blade screwdrivers
- Spirit level
- Pliers and wire cutters
- Scissors/Knife
- Service tools set
Pan calibration and setup tools
- Alignment cone assembly
- Prüfkörper digital test tool for countries where this
test is required (optional, not supplied with the
unit), see chapter 6.5.14 Panoramic Quality Check
(optional).
3D calibration and setup tools
- 3D calibration phantom
- QC phantom