KaVo MASTERmatic LUX M10 L, Instructions For Use Manual, Page: 21 / 26

Instructions for use MASTERmatic LUX M10 L - 1.009.3570
7 Reprocessing steps in accordance with ISO 17664 | 7.5 Care products and systems - Servicing
Servicing the clamping chuck
KaVo recommends cleaning and servicing the chuck system once a week using the
collet servicing program integrated in the device.
See also:
2
Instructions for Use KaVo QUATTROcare PLUS 2124 A
Note
Handpieces must be taken off the service couplings before the chuck service can
be started and performed.
▶ Remove the service coupling chuck from the side hatch of the QUATTROcare
PLUS and attach it to coupling service point four, on the far right. A MULTIflex
adaptor must be mounted there.
▶ Press the handpiece together with the guide bush of the chuck to be serviced
against the tip of the service coupling.
▶ Press the button marked with the chuck service symbol.
Note
Close the chuck service mode.
Option 1: Place the dental handpieces in the QUATTROcare PLUS 2124 A, close
the front door and start theservice procedure.
Option 2: After three minutes with no service procedure running, the device auto‐
matically switches back to normal service mode.
See also:
2
Servicing with KaVo QUATTROcare PLUS
7.5.5 Servicing with KaVo QUATTROcare CLEAN 2140 A
Programme-controlled cleaning and servicing device for perfect servicing of handpie‐
ces and turbines.
▶ Remove the cutter or grinder.
▶ Servicing the product in QUATTROcare CLEAN.
See also:
2
Instructions for use KaVo QUATTROcare CLEAN 2140 A
Servicing the clamping chuck
KaVo recommends cleaning and servicing the chuck system once a week using the
collet servicing program integrated in the device.
See also:
2
Instructions for use KaVo QUATTROcare CLEAN 2140 A
21 / 26