Instructions for use INTRA K-LUX 200 – 1.000.6717, INTRA K-LUX 200 F – 1.002.1912
7 Reprocessing steps in accordance with ISO 17664-1 / ISO 17664-2 | 7.3 Automated reprocessing
22 / 28
1
4
Do not take sleeve
①
off the motor.
Manual external cleaning
4
Thoroughly wipe down the outer surfaces of the medical device with
a CaviWipes cleaning and disinfection wipe to remove all visible deposits.
4
Thoroughly wipe down the outer surface of the medical device with a
second CaviWipes cleaning and disinfection wipe to remove any remaining
invisible contaminations.
Manual external disinfection
4
Finally, thoroughly wipe down the outer surfaces of the medical device with
a third CaviWipes cleaning and disinfection wipe and allow the agent to act
as detailed by the manufacturer of the disinfectant (3 min).
4
Follow the instructions for use of the disinfectant.
NOTE
Cleaning and servicing of the site of coupling.
To maintain uninterrupted operation, it is recommended to clean the grooves
for the O-rings semi-annually.
4
For this purpose, take all 3 O-rings off the coupling peg and remove all ad-
hering particles and lime scale from the grooves using a wet, lint-free cotton
cloth.
NOTE
If the connection to the instrument is not leak-proof, replace all O-rings.
7.2.2 Manual internal cleaning
Not applicable.
7.2.3 Manual internal disinfection
Not applicable.
7.2.4 Manual drying
CAUTION
Moisture.
Corrosion and other product damage.
4
Store motors in a dry place.
4
If there is any residual moisture after cleaning and disinfecting, soak up the
residual moisture with a soft cotton cloth and then wipe dry.
4
Carefully apply low doses of compressed air to the inside and outside of the
disassembled sleeve until no droplets of water are visible any longer.
7.3 Automated reprocessing
Not applicable.
7.4 Care products and systems - Servicing
The bearing sites of the motors are provided with a high-quality, lifelong lubric-
ation.
