Instructions for use INTRA K-LUX 200 – 1.000.6717, INTRA K-LUX 200 F – 1.002.1912
3 Description of the product | 3.2 Technical Specifications
12 / 28
3.2 Technical Specifications
NOTE
The motor is only approved in combination with the listed treatment units and
small devices.
NOTE
Technical specifications, such as torque and speed, depend on the motor elec-
tronics used and may deviate from the data given if other controls are used in
combination with the motor. The technical specifications are described in the
respective instructions for use of the control unit used.
can be combined with
▪ ESTETICA 1065
▪ ESTETICA 1066
▪ Status 1080
▪ Globus 1078
▪ Primus 1058
Motor voltage rating
26 V DC
Motor speed rating
40,000 rpm
Motor torque rating
2.6 Ncm
Connector
Straight and contra-angle handpieces
with INTRAmatic connection according
to DIN EN ISO 3964
4
For information about the connected loads on the device side, please check
with the manufacturer.
Media supply at motor intake
Cooling air (system pressure)
2.5 to 4.5 bar (36 to 65 psi)
Amount of cooling air at motor intake
32 ± 4 NL/min
Spray air pressure
1.0 to 2.5 bar (15 to 36 psi)
Spray water pressure
0.8 to 2.0 bar (12 to 29 psi)
Media exit at instrument coupling
Cooling air exit at instrument coupling 7.5 ± 1.5 NL/min
Spray air flow rate
>1.5 NL/min at 1.0 bar (15 psi)
Spray water flow rate
> 60 ml/min at 0.8 bar (12 psi)
Air requirements
Air quality in accordance with DIN EN
ISO 7494-2
dry, oil-free, dirt-free, non-contamin-
ated
Air filter, supplied by customer
< 20 μm
