KaVo 3D eXam, Operator'S Manual

Page: 166 / 170

iCATVision Quick Reference
990330 September 14, 2007
C-2
Suggestions for Adjusting Panoramic Map
Start adjusting the Panoramic map from the Preview Screen. It is
recommended to center the anterior point at midline and then move the
next two points up closer to the anterior point on each side. Place them
a few teeth away from anterior center. Then move the next two points
closer to the molars.
Filtering Defaults
There are already filters applied to all images. The filters are defaulted
as seen below.
1.
Preview Screen: Hard all images.
2. Implant Screen: Hard all images.
3. TMJ Screen: Hard for first 3 and Normal for Condyle Ortho Images.
4. MPR Screen: Normal all images.
5. Ceph (Ortho) Screen: Very Sharp for Upper Left Right Lateral and Hard for all others.
These defaults can always be changed by clicking Tools > Filter Settings > Set Filters. They
can also be changed “on the fly” by right clicking an individual image, selecting Filter Setting
> Set Filter and clicking the desired option (Smooth, Normal, Hard, Sharp, Very Sharp). They
can be changed back to the default by clicking Tools > Filter Settings > Reset to Default.
Removing Circumference Artifact
Circumference Artifact are seen visually in the Preview Screens as horizontal lines in the Coronal
and Sagittal images and a white partial circle around the axial image. This can be removed from the
dataset by right clicking the screen and selecting
Remove Data Outside of Center Scanfield . The
data re-calculates and the image is displayed without that artifact.
Saving and Loading Workups
Created plans can be saved for retrieval. When a plan is changed and an attempt to exit or switch
patients is made, iCATVision prompts to save the workup. To save the workup, click
Yes . A window
is displayed to Create New Workup . Click this button and enter a new title for your workup or
choose an existing workup name (if one) from the list to overwrite. Once the workup is named, click
OK to save.
Or, before exiting or switching patients, from the Preview Screen, right click to access the pop up
menu and select
Save this Workup . Then proceed as instructed above.
To load a workup, click a Patient Name, and Patient Image, and then a workup. If you want to select
another workup (if you have multiple workups), right click the screen to access the pop up menu and
select
Load Different Workup . Then select the workup from the list.