Kathrein ZAS 40, Quick Start Manual

Page: 1 / 2

1 / 2
ZAS 40 20410011
ZAS 41 20410012
Rafter fasteners for the sat antennas CAS 06/60/80/90 and KEA 650/750/850/1000
About this guide
This document is part of the product.
► Do not install or use the device until you have read and understood
this document.
► Perform all operating steps described in this manual in the specified
sequence.
► Keep this document for reference throughout the service life of the
device. Pass this document on to any new owner or user.
For the most up-to-date version of this document, go to
www.kathrein-ds.com .
Features
■ TÜV certified for parabolic antennas with a diameter of up to Ø 1 m
■
ZAS 41 for one parabolic antenna
ZAS 41 for one parabolic antenna and an additional VHF antenna
■
Mounting directly from the outside or through the battens onto the
rafter
■ Flexibly adjustable to the gaps between the rafters by means of a
telescopic tube
■ Continuously adjustable for any roof slope (limited only by the cover
plate)
■ Hot-dip galvanised
■ Cable is inserted through mast tip by means of the ZTC 08 (included
in the scope of delivery of the ZTS 40/ZTS 41ro/ZTS 41sw)
■ Designed to withstand lightning current (100 kA, 10/350 µs according
to DIN VDE 0855-300)
Scope of delivery
● Rafter fastener
● 6 wood screws 10 x 100 mm
● Earthing terminal
● Mast cover
● 4 nuts M10
● Fastening screw M10 x 20
● User manual
ZAS 40 and ZAS 41 are rafter fasteners for mounting parabolic antennas with a diameter of up to Ø 100 cm on the roof.
Any other use, or failure to comply with these instructions or documentation and instructions enclosed with the devices, will result in voiding of
warranty or guarantee.
Intended use
Technical data
Type Unit ZAS 40 ZAS 41
Order no. 20410011 20410012
Length mm 900 1300
Diameter mm 48 48
Gaps between rafters mm 510 – 900
Roof slope ° 0 – 90
Rafter frame dimensions mm 580 – 980 x 148 x 40
Suitable for sat antennas CAS 06/CAS 60/CAS 80/CAS 90, KEA 650/750/850/1000
Suitable mounting accessories see „Mounting sets ZTS 40/ZTS 41ro/ZTS 41sw“ on page <?>
Packing unit mm 940 x 190 x 115 1350 x 190 x 115
Perm. bending moment Nm 700
Packing unit/weight, approx. pc./kg 1/6.5 1/7.5
Mounting sets ZTS 40/ZTS 41ro/ZTS 41sw
● For securing the rafter fasteners ZAS 4x
● Consists of:
– ZTB 61: Lead cover plate (410 x 410 mm)
ZTB 60ro/ZTB 60sw: Aluminium cover plate (500 x 450 mm)
– ZTC 08: Mast cap for insertion of eight or ten cables
– ZTC 48: Cover collar (ø 48 mm)
The items in the sets are
also available individually.
Please find further moun-
ting accessories under
www.kathrein-ds.com