3 / 8
Arrangement and function
Device elements
1
2
3
4
7 8
8
9
6
5
10
11
12
13
USB
UFO Link
14
Fig. 1: Device elements
①
4 x Sat-IF input, F socket
⑨
Earthing screw
②
1 x terrestrial/cable input, F socket
⑩
Power supply
1)
③
Screw for fixing to the wall mounting plate
⑪
Master LED; see below for more info.
④
Test output, signal level –25 dB, F socket
⑫
Status LED; see below for more info.
⑤
DVB-C output, F socket
⑬
Reset button; see below for more info.
⑥
Network port, RJ45
⑭
Cover of the CI slots
⑦
USB port, type B, communications interface
UFO link
for connection to the UFOmini
master
2)
⑧
2 x USB ports, type A:
USB
:
Software update by USB stick
UFO link
: Communications interface
UFO link
for connection to the UFOmini
slave
3)
1)
The power supply cable is integral to the device and is not shown here.
2)
If the head-end is the slave; see below for more info
3)
If the head-end is the master; see below for more info
LEDs and reset button
Master LED
green the head-end is the
master
off the head-end is a slave
Status LED
green OK
green, flashing software update in progress
red error
orange head-end starting
orange, flashing head-end is being identified by the
USW 800 configuration software
Reset button
Press < 5 s
1)
the head-end
will reboot
.
Press > 5 s
1)
the head-end will reset to the
factory settings
and will reboot.
Do not release the
reset button until the status LED lights up orange.
Press > 5 s
1)
the head-end will look for an update on the connected USB stick, perform the
update and reboot.
2)
1)
To prevent accidental activation, the reset button is recessed. To activate the reset button, use a tool such as a ball-point pen.
2)
Pre-requirement: There is a valid update file on the USB stick. See the USW 800 configuration software for more info.
