23
Useful information for installing the receiver on a TV set:
For installation by attachment to the rear of a TV set, securing with two screws is suf
fi
cient.
The equipment must have one of the following hole patterns (for wall mounting) on its rear panel:
100 x 100; 100 x 200; 200 x 200 or 200 x 400. If this is not the case, a VESA adaptor plate can be
obtained from a specialist dealer.
Before installing the receiver it is essential you read the section “Wall mounting” (or the equivalent)
in the user instructions for your TV set. This will tell you the screw diameters (M4, M6 or M8) and most
importantly the permissible screw penetration depth.
Before starting any installation work, it is essential you disconnect all the units
concerned from the mains. If the screws penetrate too deeply into the TV set
they may damage it beyond repair and create the risk of a fatal electric shock!
Under no circumstances install the receiver between the TV and a wall support!
Installation on the rear panel of a TV set is permissible only if the TV set is
resting on a stand that is attached in some other way.
INSTALLATION AND CONNECTION
Marking out the screw/drill points at the installation location:
This diagram is to assist you in marking out the exact screw/drill points at the installation location.
↑
Rear of the receiver
Front of the receiver
↓
