LE80 Radio Receiver
Programming | en
19
TeleAlarm
User Manual
LE80_UM_EN_V1.1_2021.12
5.7
Manual programming a door address in
modes 3, 4 or 7
You can program a door address stored in a transmitter
with Locating function, in modes 3, 4 or 7.
To start programming
–
Press button T1 min. 1 second and max. 3 seconds.
Device behavior
–
LED 1 stays permanently green.
–
LED 2 blinks red slow for max. 30 seconds.
–
Activate the transmitter with Locating function, which
you desire to match, before the end of the 30 seconds.
–
Upon activating the transmitter, LED 1 and LED 2 blink
alternating green-red quick for 6 seconds.
This indication confirms that the door address of the
transmitter with Location function is matched in the LE80
Radio Receiver.
5.7.1
Programming in modes 6
It is neither possible nor necessary to program a transmitter
in mode 6 (open Receiver).
NOTICE!
A door address must be stored beforehand in a transmitter
with Locating function. That could also be done using the
PR80 and NCCM software.
NOTICE!
Only one door address can be matched in the LE80 Radio
Receiver.
CAUTION!
When a new door address stored in a transmitter is
programmed, it overwrites the current door address.