46
KATANA S610M Inverter Specialized for Elevator Manual
Function Code
Parameter Name
Setting Range
Factory Default Value
of F03.13, the inverter reports E035 error (overspeed error).
Set F03.13 = 0, and the system does not detect overspeed error.
F03.14
Speed deviation range
0: Prohibited
1.0%~50.0%(F00.04)
：
Speed
deviation range
20%
F03.15
Detection time of speed deviation
0: Prohibited
0.1~5.0 s
：
Detection time
1.0
When the deviation between given-speed (after acceleration/deceleration) and elevator’s actual operation speed
exceeds the set value of F03.14, and the maintaining time of deviation exceeds the set value of F03.15, the inverter
reports error E034 (overlarge speed deviation error).
When set F03.14 or F03.15 to 0, the system does not inspect speed deviation error.
F03.16
Crawling speed
0.020~0.500 m/s
0.050
This parameter is to define elevator speed when forced deceleration is valid.
F03.17
Multi-speed inspection&Maintenance
selection
0
～
7
0
This parameter is to define that when digital input terminals are not enough, inspection&maintenance
operation can be realized through the combination of multi-speed terminals (MS1
～
MS3).
0: Invalid
1
～
7
：
the corresponding multi-speed is 1
～
7
（
F03.01
～
F03.07
）
when none of the digital input terminals is set
as inspection operation terminal INS. When the value of multi-speed terminal is set as that of F03.17, the elevator
enters into inspection&maintenance operation mode.
Note: this function is invalid when any digital input terminal is set as inspection operation terminal INS, and
the inspection speed is set by F03.08.
6.5
Analog input curve (Group F04) (Reserved)
6.6 Acceleration and Deceleration Parameters (Group F05)
Function
Code
Parameter Name
Setting Range
Factory Default
Value
F05.00
Rapid deceleration when stops
0.020~9.999 m/s
3
0.350
This parameter defines the variation rate of deceleration speed from non zero-speed to zero-speed.
It is for adjusting the smoothness when elevator stops and improving comfort degree.
F05.01
Acceleration speed
0.020~9.999 m/s
2
0.550
F05.02
Rapid acceleration at the beginning
0.020~9.999 m/s
3
0.350
F05.03
Rapid acceleration near the end
0.020~9.999 m/s
3
0.600
F05.04
Deceleration
0.020~9.999 m/s
2
0.550
F05.05
Rapid deceleration at the beginning
0.020~9.999 m/s
3
0.600
