CORDLESS HEAT GUN INSTRUCTION MANUAL
18V CHARGE-ALL
18V CHARGE-ALL
18V CHARGE-ALL
HOW TO INSTALL NOZZLES
HOW TO REMOVE NOZZLES
HOW TO USE HEAT GUN
1. ENSURE SAFETY
1. SLIDE NOZZLE ONTO TIP
1. TWIST NOZZLE
RELEASE COLLAR (2)
2. NOZZLE DROPS
3. OPERATE HEAT GUN
Avoid holding the heat gun too close to the workpiece, 30cm is the
recommended minimum distance
Allow adequate time for the heat gun to cool down after use. When
trigger is released, the automatic cool-down function begins. Please
note, this does not cool down the tip or nozzles. The intended
function is to remove excess heat from the internals of the heat gun.
Always wear safety glasses when working with the heat gun.
Make sure to secure your hair and any baggy clothes. In
appropriate situations make sure you wear ear muffs, a mask or
a respiratory mask.
Operate the heat gun by pushing the trigger lock off (4) and then
pulling the trigger (5) and waving the heat gun side to side over the
workpiece.
2. KEEP HEAT GUN FROM SURFACE
4. ALLOW TO COOL
18V CHARGE-ALL
18V CHARGE-ALL
18V CHARGE-ALL
1
1
1
2
3
2
4
30cm minimum
5 Minutes
Australia & Global
www.katanapowertools.com.au
+61 3 9730 7100
Made to Katana
specifications and
quality standards
in China.
NOT INTENDED
FOR TRADE USE
18V CHARGE-ALL
18V CHARGE-ALL
* Standard 3 year warranty with an additional 2 year warranty available subject to online registration via katanapowertools.com.au. Warranty on this Katana
product is given by Kincrome Australia Pty Ltd of 3Lakeview Drive, Caribbean Park, Scoresby, Victoria, Australia (Tel +61 3 9730 7100) If this product
has materials or workmanship defects (other than defects caused by abnormal or non warranted use) you can, at your cost, send the product to place of
purchase, an authorised Kincrome service agent or one of Kincromes addresses for repair or replacement. Your rights under this warranty are in addition to
any other rights you have under the Australian Consumer Law or other applicable laws. Our goods come with guarantees that cannot be excluded under
the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. For further details
please visit www.kincrome.com.au or call us. Due to minor changes in design or manufacture, the product you purchase may sometimes differ from the one shown on the packaging.
WARRANTY
*
5 YEAR
220090
WARNING
TIP AND ATTACHMENTS GET EXTREMELY HOT DURING AND AFTER USE, ALLOW ADEQUATE COOLING TIME BEFORE TOUCHING
MAINTENANCE
This power tool normally requires no maintenance; from time to time the ventilation slots on the motor casing should be cleaned
out. If the unit should become defective, repair should be performed by an authorized service agent for electric tools.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
Warning!
Do not at any time let brake fluids, gasoline, petroleum based products, penetrating oils, etc., come in contact with plastic
parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
